Mobile Paint Correction Sydney
Swirl & Scratch Removal

• Single Stage: ~4–7 hours (wash/decon, one correction pass, refine & protect).
• Two Stage: ~7–12 hours (cut + polish, extra inspection time).
• Showcar: typically 1–2 full days (multi-stage refinement + graphene coating).

Times vary with size, condition and add-ons (pet hair, coatings, etc.).

We remove or dramatically reduce swirl marks, haze and light defects. Deep scratches that cut through the clear coat (or chips, peeling clear) are outside the scope of polishing.

We’ll point out any through-clear or extreme defects during assessment and discuss safe options (touch-up, wet-sand/refinish, or leave as is).

Yes—performed properly. We take paint-depth readings, use the least-aggressive approach, mask edges and sensitive trims, and avoid chasing defects where the clear is thin.

Correction removes a microscopic amount of clear coat to level the surface; we prioritise gloss and safety over risky “100% defect removal”.

Highly recommended. Correction exposes fresh, ultra-glossy paint—ceramic/graphene coatings lock in that finish, boost hydrophobicity and make washing safer. Sealants/waxes are fine, but coatings last much longer.

Depends on wash technique and protection. With good two-bucket/contact-safe washing, a corrected and coated car can stay swirl-free looking for years. Poor washing (dirty sponges, automatic brushes) re-introduces marring quickly.

See our Aftercare Guide for the exact routine.

Usually, yes—provided access and strata rules allow it. We’ll confirm:

• Clearance: ~2.0–2.2 m height for our equipment/vehicle.
• Space: room to open doors and walk around the car.
• Power/water: helpful if available; we’re self-contained when needed.

No machine polishing in active rain or high winds. If the forecast is unsafe, we reschedule at no cost. Covered carports/garages are ideal on wet days, and we’ll keep you updated with an ETA window.